KUS600 series ultrasonic sensor
1. Ultrasonic sensor | Ultrasonic level distance sensor Dimensions
Unit in the diagram is mm.
2. Electronic interface and signals definition
| Cable color | Pin | Description | Note |
| Red | 1 | Power supply | |
| Black | 2 | GND | |
| Yellow | 3 | Analogue output | The 600B will work in mode 1 or 0 cannot work in power save mode, if the 4-20mA, 0-3.3V 0-5V analogue output used. |
| Blue | 4 | RS485A | TTL-TXD for ttl output signal |
| Green | 5 | RS485B- | TTL-RXD for ttl output signal |
For switch output
| Cable color | Pin | Description | Note |
| Red | 1 | Power supply | |
| Black | 2 | GND | |
| Yellow | 3 | Switch output | Load current 1A@60V |
| White | 4 | Switch output | |
| Brown | 5 | RS485A | TTL-TXD for ttl output signal |
| Green | 6 | RS485B- | TTL-RXD for ttl output signal |
| 6 | RS485B- | TTL-RXD 用于 ttl 输出信号 |
3. Ultrasonic sensor | Ultrasonic level distance sensor Parameter
General specifications
| 600B | |
| Sensing range | 600… 5000 mm@3.3V power supply. The measure distance can reach 6 meters if the power supply is 24V. |
| Adjustment range | 300….5000mm |
| Unusable area | 0 … 600 mm |
| Response delay | approx. 10 ms |
Electrical specifications
| Operating voltage UB | 3.3 … 24 V DC , ripple 10 %SS |
| No-load supply current I0 | ≤ 20 mA active period and ≤0.3mA during sleep time |
4. Description of ultrasonic sensor |ultrasonic level distance sensor Functions
The detail refers to the 600B software engineer application guide.
5. Installation conditions of ultrasonic sensor
If the sensor is installed at the environment temperature fall below 0℃,It should do well on the protective measures.
In case of direct mounting of the sensor in a through hole using the steel nuts, it has to be fixed at the middle of the housing thread.
6. Ordering information
| KUS | Body size | OUTPUT | Max range | Description |
| 600 | ||||
| Customized | Customized | |||
| SW | Switch Output （online configurable for NPN or PNP） | |||
| mA | 3 wire 4-20mA output | |||
| 10V | Output is Vout 0-10V | |||
| 5V | Output is Vout 0-5V The power supply range is 5.0 at least | |||
| 3.3V | Output is Vout 0-3.3V The power supply range is 3.3 at least | |||
| RS485 | Output is RS485 | |||
| TTL | UART TTL output | |||
| XXX mm | Xxx mm is the maxim range can be detected, the default length is 1 meter | |||
| KUS | 600 | RS485 | 5000mm | |
Appendix: Influence of Side Lobe Effect on Ultrasonic Sensor Installation
